IT-Type EPDM Rubber Dock Bumpers For Protect Shipboard , 2000H
- Rated deflection can up to 57.5% with higher energy absorption.
- The frontal frame with UHMW-PE can lower friction factor and the
shear strength while vessel berthing and raise fender service life.
- Various length or size can be obtained according to the actual
- The largest size can up to 2000H.
- Good angular performance
- Wide range of sizes
- High efficiency
- PIANC tested and certified
- Modular design
IT-type rubber fender provides a compact solution to mounting
fenders in limited areas. IT-type rubber fenders have a narrower
footprint than traditional leg fenders. They can be mounted behind
a panel or pile.
IT-type rubber fender have a long track record and are well suited
to berth and terminals handing all vessel sizes.IT-type rubber
fender can be used in arrays with frontal frame ,or it can also be
used with a UHMW-PE shield to provide a low cost alternative to an
High reaction force (P1)
Standard reaction force (P0)
Note: Rated deflection 50%
1. The design compress deformation is 57.5% and its energy
absorption is around 10% higher than that of super arch (TD-B)
2. Small installation scale provides it broader application range.
TD-B500H fender's mounting bolt center distance is 840mm, much
shorter than 600mm owned by TD-IT500H.
3. It enjoys facile design, suitable for vertical, horizontal as
well as mixed arrangement.
4. The front part is fixed with frontal frame and pressure on
fender face can be set according to specific need.